centos7内核优化收集

0 日志 发表评论

cat /etc/sysctl.conf
#CTCDN系统优化参数
#关闭ipv6
net.ipv6.conf.all.disable_ipv6 = 1
net.ipv6.conf.default.disable_ipv6 = 1
#决定检查过期多久邻居条目
net.ipv4.neigh.default.gc_stale_time=120
#使用arp_announce / arp_ignore解决ARP映射问题
net.ipv4.conf.default.arp_announce = 2
net.ipv4.conf.all.arp_announce=2
net.ipv4.conf.lo.arp_announce=2
# 避免放大攻击
net.ipv4.icmp_echo_ignore_broadcasts = 1
# 开启恶意icmp错误消息保护
net.ipv4.icmp_ignore_bogus_error_responses = 1
#关闭路由转发
net.ipv4.ip_forward = 0
net.ipv4.conf.all.send_redirects = 0
net.ipv4.conf.default.send_redirects = 0
#开启反向路径过滤
net.ipv4.conf.all.rp_filter = 1
net.ipv4.conf.default.rp_filter = 1
#处理无源路由的包
net.ipv4.conf.all.accept_source_route = 0
net.ipv4.conf.default.accept_source_route = 0
#关闭sysrq功能
kernel.sysrq = 0
#core文件名中添加pid作为扩展名
kernel.core_uses_pid = 1
# 开启SYN洪水攻击保护
net.ipv4.tcp_syncookies = 1
#修改消息队列长度
kernel.msgmnb = 65536
kernel.msgmax = 65536
#设置最大内存共享段大小bytes
kernel.shmmax = 68719476736
kernel.shmall = 4294967296
#timewait的数量,默认180000
net.ipv4.tcp_max_tw_buckets = 6000
net.ipv4.tcp_sack = 1
net.ipv4.tcp_window_scaling = 1
net.ipv4.tcp_rmem = 4096        87380   4194304
net.ipv4.tcp_wmem = 4096        16384   4194304
# default write buffer
net.core.wmem_default = 8388608
# default read buffer
net.core.rmem_default = 8388608
# max read buffer
net.core.rmem_max = 16777216
# max write buffer
net.core.wmem_max = 16777216
#每个网络接口接收数据包的速率比内核处理这些包的速率快时,允许送到队列的数据包的最大数目
net.core.netdev_max_backlog = 262144

# max backlog
net.core.somaxconn = 4096

#限制仅仅是为了防止简单的DoS 攻击
net.ipv4.tcp_max_orphans = 3276800
#未收到客户端确认信息的连接请求的最大值
net.ipv4.tcp_max_syn_backlog = 262144
net.ipv4.tcp_timestamps = 0
#内核放弃建立连接之前发送SYNACK 包的数量
net.ipv4.tcp_synack_retries = 1
#内核放弃建立连接之前发送SYN 包的数量
net.ipv4.tcp_syn_retries = 1
#启用timewait 快速回收
net.ipv4.tcp_tw_recycle = 0   #来自 https://github.com/shadowsocks/shadowsocks/wiki/Optimizing-Shadowsocks的警告  为了对NAT设备更友好,建议设置为0
#开启重用。允许将TIME-WAIT sockets 重新用于新的TCP 连接
net.ipv4.tcp_tw_reuse = 1
net.ipv4.tcp_mem = 94500000 915000000 927000000
net.ipv4.tcp_fin_timeout = 30   #1
#当keepalive 起用的时候,TCP 发送keepalive 消息的频度。缺省是2 小时
net.ipv4.tcp_keepalive_time = 1200
net.ipv4.tcp_keepalive_probes = 3
net.ipv4.tcp_keepalive_intvl = 15
#允许系统打开的端口范围
net.ipv4.ip_local_port_range = 1024    65000
#修改防火墙表大小,默认65536
net.netfilter.nf_conntrack_max=655350
net.netfilter.nf_conntrack_tcp_timeout_established=1200
# 确保无人能修改路由表
net.ipv4.conf.all.accept_redirects = 0
net.ipv4.conf.default.accept_redirects = 0
net.ipv4.conf.all.secure_redirects = 0
net.ipv4.conf.default.secure_redirects = 0
vm.swappiness = 10
kernel.panic = 5
# max open files
fs.file-max = 165535
# for high-latency network
net.ipv4.tcp_congestion_control = hybla
#maximize the available memory
vm.overcommit_memory = 1
vm.dirty_ratio = 1
vm.swappiness = 10
vm.vfs_cache_pressure = 110
#vm.zone_reclaim_mode = 0

#keep the IO performance steady
vm.dirty_background_ratio = 1
vm.dirty_writeback_centisecs = 100
vm.dirty_expire_centisecs = 100

# turn on path MTU discovery
net.ipv4.tcp_mtu_probing = 1

#关闭快速打开
net.ipv4.tcp_fastopen = 3

#/etc/security/limits.conf
* soft nofile 51200
* hard nofile 51200

#开启ss前
     
ulimit -n 51200

#加载/sbin/modprobe tcp_hybla
/sbin/modprobe tcp_hybla

#sysctl net.ipv4.tcp_available_congestion_control 查看算法

/etc/sysctl.conf
# for high-latency network
net.ipv4.tcp_congestion_control=hybla

sysctl -p

发表评论

您的电子邮箱地址不会被公开。 必填项已用*标注

昵称 *

此站点使用Akismet来减少垃圾评论。了解我们如何处理您的评论数据